Appliance Installation; Wall Installation - Olimpia splendid CALDO CRYSTAL Instruccioes Para La Instalación, Uso Y Mantenimiento

6 - APPLIANCE INSTALLATION

After removing the packaging, make sure of the appliance integrity; in case of doubts,
do not use it and please refer to professionally qualified personnel.
The appliance must be installed on a masonry or made of heat resistant material wall
(not wooden or made of easily overheatable synthetic material).
For the correct installation, work as follows:
The appliance must be installed:
• in such a way as to prevent the ON/OFF switch and the buttons
from being touched by who is standing in the bathtub or in the
shower.
• At a distance of at least 300 mm from walls
• At a distance of at least 1000 mm from flammable materials (cur-
tains, textiles etc.)
DO NOT install the appliance beneath power outlets.
Prepare a power outlet in the vicinity of the appliance making sure
it's not too far in relation to the power cord length (figure C).
a. Locate the area where the appliance is going to be installed.
b. Create two due 6mm holes with a centres distance of 494mm (figure D).
The holes must be at least 2000mm away from the floor 350mm
from the ceiling (figure D).
When piercing the wall, make sure that no electrical channels or
water hoses are present.
c. Insert the wall plugs in the holes and then fasten the supplied screws.
d. Do not fasten the screws entirely; leave them approximately 10 mm away from
the wall (figure E).
Make sure that the screws are well steady in the wall
EN - 10

6.1 - Wall installation

.