Basic Setup And Configuration; General Functions; Spoken Status Announcements; Audio Sources And Priorities - SCHUBERTH SRC-SYSTEM Guía De Usario

4. BASIC SETUP AND CONFIGURATION

4.1 GENERAL FUNCTIONS

DESIRED RESULT REQUIRED ACTION
Turn on the headset
Press the Mobile Button steadily for at least four
seconds
Led indication: Three blue flashes.
Audio feedback: Ascending tone (low-high).
Turn off the headset
Press the Mobile Button steadily for at least three
seconds
Led indication: Three red flashes.
Audio feedback: Descending tone (high-low).
Increase the volume Tap the Volume Up Button
Decrease the volume Tap the Volume Down Button
Mute
Simultaneously tap Volume Up and Volume Down
while any audio is on
Battery Level While on standby, press and hold the Volume Up
Indicator Button for 3 seconds
Blue light = Battery is fully charged
Red/blue light = Battery is half full
Red light = Battery is almost empty

4.2 SPOKEN STATUS ANNOUNCEMENTS

Your SRC-System™ headset offers various audio status messages
sent through your speakers. Among others, it will announce your
connection state, e.g. whether you are in mobile phone or on
intercom mode, it will confirm changes of such modes and more. By
default the feature is ON, and can be disabled as outlined below.
The Voice menu can be set at any one of the available language op-
tions. In the future, more languages will be available for downloading
from our website (see section 4.4 for Firmware Upgrade).
Entering the Voice Menu: Press and hold the CHANNEL "A" button
and CHANNEL "B" button simultaneously for 3 seconds while the
headset is on standby. Now, follow the voice instructions in English
or choose your preferred language.
Disable/Enable status announcements: While on standby, press
and hold the Volume Down Button for 6 seconds.
Led ON: indication: Solid blue + Audio feedback: One short beep
Led OFF: indication: Solid red + Audio feedback: Two short beeps

4.3 AUDIO SOURCES AND PRIORITIES

The different audio sources connected to the SRC-System™ are
prioritized as shown below, i.e. the higher priority source will always
override and interrupt the lower one.
For example, incoming mobile phone calls will interrupt ongoing
Intercom calls, while incoming intercom calls will interrupt the audio
from the built-in FM Radio etc.
1. Mobile phone audio or GPS instructions
Higher Priority

(device specific)
2. Intercom
3. A2DP audio source
4. FM Radio (built-in)
5. Auxiliary Line-In Port (for corded connection
Lower Priority
e.g. MP3 players).

4.4 FIRMWARE UPGRADE OPTION

In the future you will be able to install firmware upgrades and program
patches to keep the software of your SRC-System™ up-to-date. Among
others, future firmware upgrades will include
additional status announcements and other valu-
able functions. To ensure that you don't miss out on the latest versions,
please register online at www. src-system.com and have your serial
number ready. For downloading upgrades, please use the USB cable
included in the SRC-System™'s retail package.
Until further notice, upgrades will only be available for Windows®
based computers with XP™ or Vista™ operating systems.

4.5 RESETTING yOUR HEADSET

If your headset fails to respond despite repeated attempts, you can
reset your headset by charging it. After approximately 10 seconds,
25