Positioning The Microphone; Removing The Src-System From Your Helmet; Wearing And Removing The Helmet; Cleaning The Acoustic Collar - SCHUBERTH SRC-SYSTEM Guía De Usario

2. Open the two red buttons located at the bottom part of the
interior lining that cover the cheek pads (the
button on the back is held by a black ring).
Lift the lining slightly.
3. Attach the corresponding Velcro pad to the
identically shaped depression on the EPS (ex-
panded polystyrene) and position the speaker
on the Velcro pad.
4. Close the two red buttons. Make sure the red button is still inside
its black holding ring.
5. Now, close the snap buttons of the Acoustic Collar on both sides
and make sure they are securely fastened.

5.3 POSITIONING THE MICROPHONE

To assure smooth closing (flip-down) of the helmet's chin section, please
remove first its triangular Anti-Noise Pad and proceed as follows:
1. Bend the flexible microphone boom as shown in the image.
2. Press the microphone towards the center of your mouth with its
large surface facing you (not the narrow one).
3. Flip-down and close the chin section of your helmet. You may
need to use both of your hands to close the chin section properly.
4. While the chin section is closed and the visor is open, insert your hand
into the opening of the visor and push the microphone away, towards
the center of the chin section directly opposite of your mouth.
Chin
Section
Visor
5.4 REMOVING THE SRC-SySTEM™ FROM yOUR HELMET
1. Open both snap buttons.
2. Lift and push the Acoustic Collar's arch from the center.
3. Release the Acoustic Collar's pins from their corresponding indenta-
tions inside the helmet's rim.

5.5 WEARING AND REMOVING THE HELMET

The electronic components of SRC-System™ are safely embedded
inside the Acoustic Collar. To avoid discomfort while you put on your hel-
met or while removing it, we recommend that you proceed as follows:
1. Expand the helmet opening by firmly holding the chin straps and
pulling them forcefully apart.
2. While pulling the straps apart, slide the
helmet over your head, beginning from
the neck forward.
3. To remove the helmet, proceed along the
same lines by first pulling the straps apart
and then pushing the entire helmet upwards.
NOTe: Your SRC-System™ Acoustic Collar is designed for maximum
comfort. However, since it contains an entire electronic kit within, it will
somewhat bulge a bit. Therefore, putting your SRC equipped helmet on or
taking it off may feel different than what you are used to with a standard
Acoustic Collar. Remember: The more you pull the helmet straps apart
when putting on your helmet or taking it off, the smoother the process will
be, allowing the stiffness of the Acoustic Collar to decrease.

5.6 CLEANING THE ACOUSTIC COLLAR

To clean the Acoustic Collar, first close tightly the micro USB connec-
tor of the SRC-System™. Use only a slightly damp and lukewarm cloth.
Avoid soaking the Acoustic Collar with water or any other fluid. Never
submerge it and refrain from letting water come in contact with the
speakers or the microphone. Allow the unit to dry at room temperature.
27