Installation; Positioning The Unit On The Roof; Securing The Unit To The Mounting Brackets - Dometic COOLAIR RTX 1000 Manual De Instalacion Y Uso

Parking Cooler
– If more space is required between the unit and the
roof of the vehicle, use a 1.37 in. x 0.78 in.
(35 mm x 20 mm).
4. Apply a flexible, non-hardening butyl sealant to the
area between where the ends of the seal join and the
top edge of the seal.

7 Installation


WARNING: ELECTRICAL SHOCK HAZARD .
Failure to follow these warnings could result
in death or serious injury .
• Before carrying out any work on electrically operated
components, make sure that they are disconnected
from the power supply.
• Before installing the parking cooler, disconnect all
connections to the vehicle battery.
• All electrical connections must be made by a trained
technician.

CAUTION: PERSONAL INJURY HAZARD .
Incorrect installation of the parking cooler may place
the safety of the user at risk. Failure to obey this caution
could result in minor or moderate injury.
NOTICE: The parking cooler may only be installed by a
qualified technician.
NOTICE: The connection to the vehicle's electrical
system should be protected by a 80 A fuse for the power
supply and a 2 A fuse for the voltage monitor.
NOTICE: The battery must be capable of supplying the
required current and voltage.
Refer to the sections below to position and install the
unit onto the roof of the vehicle.
7 .1 Positioning the Unit on the
Roof
1. Remove the unit from the carton and discard the carton.
2. Move the unit to the roof.
I Do not slide the unit along a surface. Otherwise,
damage to the gasket on the bottom of the unit
could occur and cause a leak.
EN
14 Positioning the Unit
RTX Unit
q
3. Lift and place the unit over the prepared roof
opening.
I Once the unit is in position on the roof of the
vehicle, the seal should make contact all the way
around the underside of the unit.
7 .2 Securing the Unit to the
Mounting Brackets
q
15 Positioning the Mounting Brackets
Mounting Bracket
q
Installation
q
w
Opening
w
11