Preparing The Unit; Attaching The Seal To The Roof Opening - Dometic COOLAIR RTX 1000 Manual De Instalacion Y Uso

Pre-Installation

6 .2 Preparing the Unit

NOTICE: When preparing the unit on a work surface,
make sure it is secure and will not fall off. Make sure that
the work surface is clean and level to avoid damage to
the unit.
1. Place the parking cooler on a work surface with the
external cover facing Down.
q
A
11 Installing the M8 Threaded Plugs
M8 Threaded Plugs
q
2. Use the supplied 1/4 in. bit to screw the four self-
tapping M8 threaded plugs into the blind holes
marked "A". The maximum allowable torque for M8 is
88.5 in. lbs (10 Nm).
q
B
B
12 Installing the M6 Threaded Plugs
M6 Threaded Plugs
q
10
A
A
(Bottom Front)
B
(Bottom Front)
3. Use a 5 mm hex bit to screw the four self-tapping
M6 threaded plugs into the blind holes marked "B".
The maximum allowable torque for M6 is 70.8 in. lbs
(8 Nm).
6 .3 Attaching the Seal to the Roof
Opening
e
w
13 Attaching the Sealing Strip
Opening
q
Sealing Strip
w
1. Ensure the surface between the unit and the vehicle
roof where the seal will be glued is clean and free of
any dust or oil.
2. Glue the seal to the vehicle roof. Follow the contour
of the roof opening.
I The area between where the ends of the seal join
should be located where the rear of the unit will be
installed.
3. Install the seal using one of the following methods:
– For the most common installation situations, use a
2.75 in. x 0.78 in. (70 mm x 20 mm) seal.
Parking Cooler
w
q
(Front)
q
(Front)
Adhesive
e
Sealant
r
r
EN