Atlas Copco SB Serie Instrucciones De Seguridad Y De Funcionamiento página 14

Safety and operating instructions
Circulate the hydraulic oil before connecting the
hydraulic breaker. This is to make sure that the
hydraulic oil is clean. Use the same routine when
changing the hydraulic oil hose. For further
information see "The hydraulic oil".
1. Connect the pressure and return hose.
2. Run the hydraulic oil through the carrier's oil filter
for approximately 3 minutes to make sure that
the hoses are clean.
Preparation
1. Place the breaker in a position where it is easy
and safe to mount the adapter plate.
NOTICE! Mount the breaker so that the
accumulator faces the operator's cabin, to
reduce the risk of accumulator damage.
14
Mounting the adapter plate
2. If the Tough lock screw from Atlas Copco is not
available we recommend using NORD-LOCK™
washers under bolt and nut (NORD-LOCK™ is
a registered trademark of Nord-Lock AB in the
United States and/or other countries.).
Adapter plate
SB 52
SB 102
SB 152
SB 202
SB 302
SB 452
SB 552
© 2008 Atlas Copco Construction Tools AB | No. 9800 0648 90e | 2008-11-03
SB 52, 102, 152, 202, 302, 452, 552
Tightening torque
290 Nm
200 Nm
200 Nm
200 Nm
170 Nm
400 Nm
400 Nm