Safety and operating instructions
Never start the hydraulic breaker until both carrier
and the hydraulic breaker are in the correct position.
Direct the hydraulic breaker in a position 90°
♦
towards the object.
♦
Start near the edge and work your way in towards
the middle. Never start in the middle of large
objects.
♦
Never run the hydraulic breaker longer then 15
seconds on the same spot. Move the working tool
to a new position if the object does not break.
♦
Never bend with the working tool.
18
♦
Use the correct feed pressure. When the feed
pressure is correct the hydraulic breaker is working
at its best and the vibrations are at a minimum.
Also the wear on the bushing and tool is kept to
a minimum.
♦
Listen to the sound from the hydraulic breaker.
The sound changes if there is any bending
between the tool and bushing.
♦
Never run the breaker with the boom cylinders at
their end positions. It may cause damage to the
carrier.
Avoid idling strokes; it causes wear on both
♦
working tool and tool retainers.
© 2008 Atlas Copco Construction Tools AB | No. 9800 0648 90e | 2008-11-03
SB 52, 102, 152, 202, 302, 452, 552