4- Forage Wagon Setup And Coupling; Assembly At Receiving - JF 9000 S2 Manual Técnico De Operación

4- Forage Wagon setup and coupling

4.1- Assembly at receiving

In normal conditions, the wagon is transported with the head (1) assembled. However, if
because of technical reasons you have to remove it, assemble it according to instructions
below:
Note:
Coupling should be done on a flat and even
place.
a) Put the head on the ground, on a proper wooden
wedge.
b) Align the head ends holes with wagon coupling
points holes. Ask the aid of another person to turn the
operation easier.
c) Install the two pins (2) fastening the head ends to the
wagon. Install the counter-pins (2a).
d) Install the two gastening screws (3) of the chassis.
e) Using a proper wrench, tighten the nuts (4).
16
1
2
1
4
3
2a
2