5- Assembly And Setup To Start Operating - JF 2 Serie Manual Técnico De Operación

OPERATION TECHNICAL MANUAL - HARVESTER JF C40 C60 and C120 SERIES 2

5- Assembly and setup to start operating

Assemble the following components:
A- Outlet chute
Lift the outlet chute (1) and fasten it by the lever (2).
If the locking pressure is insufficient, regulate it through
the nuts (3).
B- Aligners
The aligners (4) align the product turning the gathering
easier.
a) Slightly incline the machine back and wedge it in a
such way that it can not get back to the initial position.
Attention:
Failure in complying with this guidance
might cause serious injury to the
operators.
b) Assemble the aligners (4), fastening them with the
screws (5), according to picture below.
c) Assemble the opening limiters (6) on the aligners (4),
fastening them with the screws (7) - See item 12 tables.
4
7
5
6
2
3
2
1
19