Using The Set - IKUSI TM70 Serie Manual De Instalación Y De Utilización

6.- USING THE SET

To ensure correct use of the equipment, follow the instructions below:
 Make sure the transmitter you are going to use is the right one, identifying the machine on the
identification label. In the case of transmitters with LCD display, you are able to edit the machine
identification label, (ANNEX B). It will allow to the operator to identify the machine before the starting of
the equipment.
 Attach the belt to the transmitter unit. Its use is recommended to prevent the equipment from falling.
 Introduce a charged battery, turn the contact key and activate the transmitter.
 To activate the system, you must first pull out the STOP button, the LED should then give an orange-
green pulse; then press the START button. If you find that the STOP button has already been pulled
out, it is necessary to push it in and then pull it out again, as this sequence will allow the check in of the
STOP circuit. If the unit has experienced a time-out auto-disconnection, it is not necessary to repeat the
STOP button procedure, simply push the START button for 1 second.
 The green LED should light up, indicating that the transmitter has started transmitting. From now on, if
any of the transmitter's command buttons are pressed, the corresponding manoeuvre will be activated.
 To be able to start up the transmitter, all the command controls associated with active manoeuvres must
be in the neutral position (not activated). This is not the case for the selection functions.
 When 4 minutes have passed and no active manoeuvre command has been activated, the transmitter
automatically goes to STAND BY mode, indicated by green pulses each 3 seconds. To start it up once
more, press the start button.
 The transmitter is equipped with a circuit for monitoring the battery level. When this level drops below a
pre-established limit, the transmitter LED starts to flash in red; 5 minutes later the transmitter switches
off, and the machine's main contactor is deactivated. During this time, the load has to be located on a
safe position. If the STOP button is activated during this time, transmitter will not start again, unless
battery is replaced.
 In transmitters with LCD, the battery power level is indicated as follows:
 3 segments:
 2 segments:
 1 segment:
 Nothing:
 To switch off the transmitter, press the STOP button or turn off the contact key.
Remember that you are going to remote control a moving piece of machinery. The safety
instructions described in chapter 2 of this manual must be strictly adhered to.
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
charge greater than 50%.
charge between 50 and 10%.
charge between 10 and 5%.
charge lower than 5%.
11