Introduction & Functional Description - IKUSI TM70 Serie Manual De Instalación Y De Utilización

17.1.- INTRODUCTION and FUNCTIONAL DESCRIPTION
The A1P4RCAN CAN expansion module provides to the TM70 receiver, 4 relays output and an analogue output
at the same time. The analogue output simulates a digital potentiometer with 64 steps available in each semi-
axis of the power supply. See the diagram block below (size ½ of LR72)
:
This CAN expansion provides to the user the following outputs :

An analogue output simulated by a digital potentiometer with 128 steps and galvanically isolated.

Free to use four relays outputs, K1, K2,K3 and K4.
These outputs are controlled by CAN BUS, writing in its addresses CANOpen frames. The CAN address of the
electronic card is conformed using the 7 jumpers of P1 connector. Jumper in position 1 corresponds with the
first bit of the CAN address. Thus, inserting several bridges it is possible to select different addresses from «1 »
7
until «127» (2 ), maximum.
Very important : The address « 0 » is not a valid address ; so the board allways must be fitted with at least one
jumper. With one jumper it is possible to configure 7 different addresses.
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
CAN
11k2
K1
K2
K3
K4
+V
VOUT
-V
GND
62