IKUSI TM70 Serie Manual De Instalación Y De Utilización página 179

OUTPUTS
Each analogue output has two serial relays that switch the output signal to one of two ways, the direct or the
inverse. If not activate any of the relays, both outputs (the direct and inverse) are disconnected.
OUTPUT PWM1
The connections of the output 1 are through 4 pole terminal plug, with the follow pin assignment:
Output 1 connector
Pin Name
VPP1
GND1
VO1
VR1
OUTPUT PWM2
The connections of the output 1 are through 4 pole terminal plug, with the follow pin assignment:
Output 2 connector
Pin name
VPP2
GND2
VO2
VR2
ISP (PROGRAMACION "IN CIRCUIT" / "IN SYSTEM")
The expansion has a connector to record "In-System" (eg. Microprocessor software update). This connector has
10 pins:
ISP connector
Pin name
ISP2
TX2
RX2
GND
RX1
TX1
ISP
VCC
MRNOT
+VI
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
Function
Power of channel 1
Ground of channel 1
DIRECT analogue PWM output of channel 1
INVERSE analogue PWM output of channel 1
Function
Power of channel 2
Ground of channel 2
DIRECT analogue PWM output of channel 2
INVERSE analogue PWM output of channel 2
Function
Input connected to the ground to place the microcontroller in recording mode
Not used
Receiving data signal
Ground
Receiving data signal
Transmisión data signal
Not used
Power supply output at 3,3 V
Reset input, active when it is connected to ground
Power supply output at 12 V (not stabilized, can vary between 8 y 22 V)
69