BH FITNESS G-6488 Instrucciones De Montaje Y Utilización página 17

1 Make sure that the mains supply
voltage matches that of the machine
before plugging it in.
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match
the pins for plug on the machine. Do
not use any type of adapter.
2 To reduce the risk of electrical
shock, always
immediately after use and before
proceeding to clean it.
3 Only plug the machine into suitably
earthed wall sockets, as shown in
Figure A. An inadequate electrical
connection may result in electrical
shocks. If the plug is not suitable for
the wall socket then change it for one
that matches, bearing in mind that the
earth wire must always be connected.
If in doubt, call BH technical services.
4 Never leave the unit unattended
when it is plugged in. Unplug it after
use.
5 Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
6 Never use
recommended by the manufacturer.
7 Do not use the machine if the mains
cable becomes damaged or worn.
8 Keep the mains cable away from hot
surfaces.
9 Do not use the machine outdoors.
10 To unplug the machine, first put the
switch to the "0" position and then
unplug it from the wall socket.
SAFETY BREAKER
This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This safety
automatically triggered if the unit is
The supply
unplug the
accessories
device will
subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
unit Should
repeatedly then the most probable
causes are:
- Abnormal working conditions,
- Treadmill belt in need of lubricant,
- Solvent based lubricants used (use
BH type),
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
not
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(A) Main structure; (7) Handelbar; (4-
1) Outer handlebar cover; (4-2 ; 4.3)
Monitor retaining knobs; (142) Central
mast retaining knob; (41) Bottom left
side panel; (42) Bottom right side
panel; (8) Allen screw M5x15; (40)
Allen screw M8x10; (37) Safety key;
(12) Bottle of lubricant; Allen key,
be
5mm, Allen key 6mm.
17
the circuit breaker
Fig.B
trip