Safety Instructions - BH FITNESS G-6446N Instrucciones De Montaje Y Utilización

SAFETY INSTRUCTIONS

This product must have an earth connection. In
the event that the appliance malfunctions then
the earth connection will redirect the electrical
current away from the machine and reduce the
risk of an electrical shock. This product is
supplied with a mains cable that has an earth
wire and a plug with an earth pin. The plug must
only be used with an appropriate wall socket,
installed correctly and connected to earth, in
accordance with local regulations.
If the equipment is not earthed
DANGER!
correctly then there is a risk of electrical shock.
If in doubt, get an electrician or technical
specialist to check that the earth connection is
correct. Do not modify the plug supplied with the
equipment, if it does not fit the wall socket then
get an electrician to install an electrical socket
that does.
This product must only be used on a 220-240
volt circuit, with an earthed socket similar to that
shown in Figure A. Make sure that the appliance
is only connected to a wall socket with the same
pin layout as the plug. Do not use an adaptor
with this appliance.
Always observe the following recommendations
when using electrical appliances:
1
Make sure that the mains supply voltage
matches that of the machine before plugging
it in. The supply voltage must be the same as
that stated on the characteristics plate and the
holes in wall socket must match the pins for
plug on the machine. Do not use any type of
adapter.
2
To reduce the risk of electrical shock, always
unplug the unit immediately after use and before
proceeding to clean it.
3
Only plug the machine into suitably earthed
wall sockets, as shown in Figure A. An
inadequate electrical connection may result in
electrical shocks. If the plug is not suitable for
the wall socket then change it for one that
matches, bearing in mind that the earth wire
must always be connected. If in doubt, call BH
technical services.
4
Never leave the unit unattended when it is
plugged in. Unplug it after use.
5
Do not allow children or the disabled to use
the appliance without the strict supervision of a
qualified person.
6
Never use accessories not recommended by
the manufacturer.
7
Do not use the machine if the mains cable
becomes damaged or worn.
8
Keep the mains cable away from hot
surfaces.
9
Do not use the machine outdoors.
10
To unplug the machine, first put the switch
to the "0" position and then unplug it from the
wall socket.
SAFETY BREAKER
This model is equipped with an electronic circuit
breaker to protect both the electronic and
electrical circuits.
This safety device will be automatically triggered
if the unit is subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the casing, to
the "0" (OFF) position.
2.- Press the circuit button (C) to reset the
unit.
3.- Next, set switch (L) to the "I" (ON) position
and the unit will be ready for use again.
Should the circuit breaker trip repeatedly then
the most probable causes are:
- Abnormal working conditions,
- Treadmill belt in need of lubricant,
- Solvent based lubricants used (use BH
type),
- Belt is too tight.
Plug the unit into a wall socket with an EARTH
terminal. Set switch (L) to Position [1].
14