Preliminary Considerations. Before The System Starts-Up; Programming The Detector Number. With Sw1; Numbering The Detectors Depending On The Number Of Groups Programmed; Number Of Groups Per Module Line - Duran Electronica EUROSONDELCO Manual De Instalación

1. PRELIMINARY CONSIDERATIONS.
Before connecting the detectors to the Control Unit, the general switch must be in the OFF position and the batteries
must not be connected. All the gas inputs of the detectors, with the exception of EXP and O
with the stoppers supplied. Follow next indications before starting-up the system.

PROGRAMMING THE DETECTOR NUMBER. WITH SW1

NUMBERING THE DETECTORS DEPENDING ON THE NUMBER OF GROUPS PROGRAMMED

Toxic Gases
1 Group Detector nº *1 to 16
2 Groups Detector nº *1 to 8
4 Groups Detector nº *1 to 4
Explosive Gases
1 Group Detector nº *1 to 16
2 Groups Detector nº *1 to 8
To configure the groups always start with the detector number marked with (*).
Group parameters are independent for type of gas, group, alarm level, ventilation level, etc.
Please remember that each group will only be able to measure one type of gas and act upon one independent active
element.

NUMBER OF GROUPS PER MODULE LINE

Detection of toxic gases will be programmed for 1, 2, or 4 groups / module line.
Detection of explosive Gases -EXP- will be programmed up to 2 groups / module line - 1 or 2 -.
The number of programmed detection groups per module line depends also on the number of ventilation speeds or outputs
Before the system starts-up.
Nº detector 1
01 On
02 Off
03 On
04 Off
05 On
06 Off
07 On
08 Off
09 On
10 Off
11 On
12 Off
13 On
14 Off
15 On
16 Off
Detector nº *9 to 16
Detectors nº *5 to 8
Detector nº *9 to 16
2 3 4
On On On
On On On
Off On On
Off On On
On Off On
On Off On
Off Off On
Off Off On
On On Off
On On Off
Off On Off
Off On Off
On Off Off
On Off Off
Off Off Off
Off Off Off
Detector nº *9 to 12
type, have to be covered
2
Detector nº *13 to 16
29
X-maneuro-INS-v04