Explanations Of The Display; Information Concerning The Buttons - Unold 68616 Instrucciones De Uso

EXPLANATIONS OF THE DISPLAY

Display
BASIC SETTING:
As soon as the appliance is plugged into the electrical
outlet, the display shows 3:00 (the colon between the
numbers does not blink). The arrows point to BASIC, Loaf
size II and Browning medium.
This indicates that the breadmaker is ready for operation.
During operation, the program status is indicated both by
the time countdown and the information on the display.
The display texts as follows:
KNETEN (1+2) = Appears whenever the appliance is in the
kneading phase.
GEHEN (1-3) = Indicates the various rising phases.
At the beginning of RISE 3 the kneader can be removed if
desired (see also program table)
BACKEN = The bread is baking.
WARMHALTEN = The bread is kept warm for 1 hour.

INFORMATION CONCERNING THE BUTTONS

START/STOP button
This button is used to start and stop the program. By
pressing the START/STOP button you can discontinue the
program at any time. For safety reasons, this button responds
with a slight delay; therefore, keep the button pressed until
you hear a signal tone. Afterwards, the start position of the
Basic program will appear. If you wish to use a different
program, select the appropriate program with the Menu
button.
MENU
The Menu button is used to select the individual programs,
which are described in detail in the program sequence
table. The number corresponding to the program appears
on the display to indicate the selected program. Use the
programs as described below:
P r o g r a m Program name
number
1 BASIS
BASIC
2 VOLLKORN
WHOLE GRAIN
3 WEISSBROT
WHITE BREAD
Program description
The standard program for
all breads, such as white
bread and multi-grain
bread
For whole grain breads
For especially light white
breads with longer rising
times
The following messages on the display indicate an error:
HHH: If this appears after pressing the START/STOP button
the appliance is still too hot from the last program. Open
the lid and allow the appliance to cool for another 10 to
20 minutes.
LLL: If this appears, then the temperature in the appliance
is too low. Open the lid and allow the appliance to warm
up to room temperature for about 10 to 20 minutes. We
recommend an ambient temperature of 15 to 34 °C.
E E0 and E E1: This message indicates a defect in the
temperature sensor. Please have the appliance inspected
by our service department.
P r o g r a m Program name
number
4 SCHNELL
FAST
5 TEIG
YEAST CAKE
6 BACKPULVER
BAKING POW-
DER
7 KONFITÜRE
JAM
8 TEIG
DOUGH
9 U L T R A -
SCHNELL
ULTRA-FAST
Program description
For faster baking of white
and multi-grain breads
For preparing sweet yeast
dough
For baked goods made with
baking powder, such as
batter cakes
For cooking jams and jel-
lies. If you use the bread-
maker for making jam, you
should purchase a second
baking pan which is used
only for this purpose.
For preparing dough, wit-
hout baking
This program is suitable for
light breads made of super-
fine flour (wheat or a mix-
ture of wheat and spelt).
This program is not suita-
ble for whole grain bread or
rye bread, nor should it be
used for sourdough bread.
37