Configuration Of The Readjustments In Calibration; Technical Parameters - Baxtran SCU Manual De Instrucciones

8. CONFIGURATION OF THE READJUSTMENTS IN CALIBRATION

1. When the user is in the normal mode of weighing, he must press the keys
2. Press the keys
* ECF-1 CALIBRATION OF ZERO + WEIGHT
Press the key
Press the key
Press the keys
Press the key
Place the weight of calibration on the platform and press the key
* ECF-2 CALIBRATION OF ZERO
Press the key
Press the key
* CALIBRATION OF WEIGHT (SPAN)
Press the key
Press the keys
Pulsar la tecla
Place the weight of calibration on the platform and press the key

9. TECHNICAL PARAMETERS

DO NOT MODIFY THE TECHNICAL PARAMETERS IF IT IS NOT STRICTLY NEEDED. A BAD CONFIGURATION OF THIS SECTION CAN
CAUSE A WRONG FUNCTIONING OF THE SCALE.
ENTRANCE AND EXIT OF THE CALIBRATION
DISPLAY
LF 1
34
to select the desired function:
,the display will show CALZ.
,to put the reading of the display to zero.
to move the cursor.
to introduce the value of the weight of calibration.
, the display will show CALZ.
, to calibration.
, the display will show the value of the weight of calibration.
to move the cursor.
to modify the value of the weight of calibration introducing all the digits.
• With the visor switched off, press and hold the key
screen, then you can release the key
• With the keys and
• Press the key to start or the key
matically.
, the message
ECF-1, ECF-2 or ECF-3
to do the calibration once the reading is steady.
to do the calibration once the reading is stable.
DESCRIPTION AND SEQUENCE OF USE
.
introduce the code 0020.
to exit the menu and the indicator will begin again auto-
USER'S MANUAL SCU
ECF-1
is going to appear on the display.
until the message P000, appears on the
EN