Worx Intellicut WG787 Manual De Instrucciones página 15

OPERATION
1. STarTiNG aND SToPPiNG (See Fig.
F1, F2, F3)
warNiNG! The Blade (15) continues
to rotate for a few seconds after the
machine is switched off. Allow the motor/blade
to stop rotating before switching "on" again.
Do not rapidly switch off and on.
STarTiNG
1) Insert Safety Key (5) into the housing of the
switch box (See Fig. F1).
2) Slide the key to the right and hold in
position (See Fig. F2).
3) Pull the Switch Lever (1) towards the handle
bar and the mower will start.
4) Release the Safety Key and begin mowing.
NoTE: The Safety Key will stay in the "on"
position as long as the operator holds the
lever tightly against the handle bar.
SToPPiNG
Release the Switch Lever and remove the
Safety Key.
2. iNSTaLLiNG MULCh PLUG (13)
(See Fig. G)
1) Turn the mower off, wait until the blade
stops and remove the Safety Key (5).
2) Raise the Safety Flap (9) and hold it up.
3) Slide the Mulch Plug into the discharge
opening until it is firmly in contact with the
deck.
4) Release Safety Flap and ensure it is
properly closed.
NoTE: Since the discharge opening is blocked,
there is no need to use the Grass Collection
Bag (4) while the Mulch Plug is installed.
3. rEMoviNG MULCh PLUG (13)
(See Fig. G)
Remove the mulch plug when you desire to
either collect grass or discharge grass from the
rear of the mower.
1) Shut the mower off, wait until the blade
stops and remove the Safety Key (5).
2) Raise the Safety Flap (9) and hold it in the
up position.
3) Grasp the handle on the Mulch Plug then
lift upward and pull it out.
4) Release the Safety Flap and ensure it is
properly closed.
3-in-1 Cordless Lawn Mower
4. iNTELLiCUT CUTTiNG MoDE SELECTioN
(See Fig. h)
QUiET MoDE
Set the IntelliCut Dial (18) to QUIET mode
(1) when mowing in everyday conditions,
removing approximately 1 inch of grass at a
time.
PowEr MoDE
Set the IntelliCut Dial to POWER mode (2)
when cutting dense or overgrown grass.
5. BaTTEry PowEr LEvEL LiGhTS
(See Fig. i)
NoTE: The Power Level Lights will indicate
the battery condition when the button on the
battery is pressed.
The Power Level Lights display the battery
condition as follows:
Press the button "POWERTEST" , the power
level light(s) button is illuminate.
When the three green lights are illuminated,
the Battery Pack (10) is in a highly charged
condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is very low and should be
recharged.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the Battery
Pack is fully charged.
iMPorTaNT
when only one light is illuminated, your
battery is discharged, even though the
mower may still be capable of cutting
grass. Continuing to operate your
lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.
6. aDJUSTiNG ThE CUTTiNG hEiGhT
(See Fig. J)
warNiNG! Stop the mower by
releasing the Switch Lever (1)
and wait until the motor stops before
adjusting height. The blades continue to
) are illuminated, the
) is illuminated,
EN
15