Worx Intellicut WG787 Manual De Instrucciones página 16

rotate after the machine is switched off,
a rotating blade can cause injury.
CaUTioN: Do not touch rotating blades.
For the first cutting of the season, a high
cutting adjustment should be selected. The
lawnmower can be set to 6 cutting heights
between 1.5" (38mm) and 3.5" (88mm).
For this purpose, pull the cutting height
adjustment lever outwards then adjust to
the preferred position.
7. GraSS BaG FiLLiNG iNDiCaTor (3)
(See Fig. K)
To alert you that the Grass Collection Bag (4)
is full, the mower provides a Grass Collection
Bag Filling Indicator on the top of the bag.
Empty status: flap floats (i)
Fully status: flap falls down (ii)
8. rEar DiSCharGE (See Fig. L)
16
The mower provides a rear discharge function,
so that you can mow while collecting or while
mulching the grass. Grass clippings will be
discharged from the rear chute of the mower
and exit below the Safety Flap (9).
9. MowiNG TiPS
warNiNG: always inspect area
where mower is to be used and
remove all stones, sticks, wire, metal and
other debris which might be thrown by
the rotating blade.
1) Mow across the face of slopes, never up-
and-down. Exercise extreme caution when
changing direction on slopes. Do not mow
excessively steep slopes. Always maintain
good footing.
2) Release the Switch Lever (1) to turn mower
"OFF" when crossing any graveled area
(stones can be thrown by the blade).
3) Set mower at highest cutting height when
mowing in rough ground or in tall weeds.
Removing too much grass at one time can
cause circuit breaker to trip, which stops
mower.
3-in-1 Cordless Lawn Mower
4) If a Grass Collection Bag (4) is used during
the fast growing season, the grass may
tend to clog up at the discharge opening.
Release the Switch Lever to turn mower
"OFF" and remove the Safety Key (5).
Remove the Grass Collection Bag and
shake the grass down to the back end of
the bag. Also clean out any grass or debris
which may be packed around the discharge
opening. Replace the Grass Collection Bag.
5) If mower should start to vibrate abnormally,
release the Switch Lever to turn mower
"OFF" and remove the Safety Key. Check
immediately for cause. Vibration is a
warning of trouble. Do not operate mower
until a service check has been made.
6) aLwayS rELEaSE SwiTCh LEvEr To
TUrN MowEr "oFF" aND rEMovE
SaFETy KEy whEN LEaviNG iT
UNaTTENDED EvEN For a ShorT
PErioD oF TiME.
10. MULChiNG MowiNG TiPS
While mulching, your new mower is designed
to cut the grass clippings into small pieces
and distribute them back into the lawn.
Under normal conditions, the mulched grass
will biodegrade quickly to provide nutrients
to the lawn. Please review the following
recommendations for optimum mulching
performance.
1) Avoid mowing when the grass is wet from
rain or dew. Wet grass may form clumps
which interfere with the mulching action
and reduce runtime. The best time to mow
grass is in the late afternoon when the
grass is dry and the newly cut area will not
be exposed to direct sunlight.
2) For best mulching performance, set the
cutting height to remove about one third
of the grass blade length, ideally no more
than 1.5 inches at one time. If the lawn is
overgrown, it may be necessary to increase
the cut height to reduce the pushing effort
and prevent overloading the motor. For
extremely heavy mulching, it is advisable
to first cut at a high cut height setting,
and then re-cut to the final cut height.
Otherwise, make narrower cuts and mow
slowly.
EN