Miller Maxstar 150 S Manual De Instrucciones página 23

Lights Indicate Which Selection Is Active
Feature 1
Trigger Method
Press and release switch
pad to see active Trigger Method.
Continue to press and release switch
pad to change Trigger Method.
.
If no action is taken within 5 seconds, the
light for Feature 1 begins to flash, and
lastTrigger Method selected remains active.
Lift Arc panel
control
2T Trigger Hold
Standard
Light Flashing = Active Feature
Light On = Selected Option Of Feature 1 Or 2
Press & Hold To Scroll Between Features .
Release At Desired Feature.
To save changes and exit
set-up mode, press and
release torch trigger, or
turn power off and wait
until lights turn off, and
then turn power back on.
Feature 2
Pulse Frequency (PPS)
Press and release switch pad to
see active Pulse Frequency. Con-
tinue to press and release switch
pad to change Pulse Frequency.
.
If no action is taken within 5 seconds,the light
for Feature 2 begins to flash, and lastPulse
Frequency selected remains active.
2.5 PPS
60 PPS
.5 PPS
1 PPS
OM-2242 Page 17