Selecting A Location, And Connecting Input Power - Miller Maxstar 150 S Manual De Instrucciones

Ocultar thumbs Ver también para Maxstar 150 S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3-9. Selecting A Location, And Connecting Input Power

Airflow Distance
Requirements
1
18 in.
(460 mm)
18 in. (460 mm)
2
1
Welding Power Source
Shoulder Strap
Use strap to lift unit.
!
Do not move or operate
unit where it could tip.
!
Installation must meet all
National and Local Codes
− have only qualified
persons
installation.
!
Special installation may be
required where gasoline or
volatile liquids are present
− see NEC Article 511 or
CEC Section 20.
.
The Auto-Line circuitry in this
2
unit automatically links the
power source to the primary
voltage being applied, either
115 or 230 VAC.
NOTICE − Do Not cut off power
4
3
cord connector and rewire. The
power cord connector and plugs
will work with standard NEMA re-
ceptacles. Modifying power cord,
connector, and plugs will void
product warranty.
For 115 volts AC input power, a
15 or 20 ampere individual
branch circuit protected
time-delay
breaker is required. For 230 volts
AC input power, see Section 3-7.
6
5
2
Power Cord Connector
3
Plug − NEMA Type 5−15P
4
Receptacle − NEMA Type
5−15R (Customer Supplied)
5
Plug − NEMA Type 6−50P
6
Receptacle − NEMA Type
6−50R (Customer Supplied)
Select plug for power supply
receptacle available at site.
Install plug onto power cord
adapter. As threaded collar is
tightened, push plug onto adapt-
er until collar is completely tight.
Connect plug to receptacle.
make
this
by
fuses
or
circuit
Ref. 803 351-D
OM-2242 Page 11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Maxstar 150 stlMaxstar 150 sth

Tabla de contenido