Kobalt KMS 0724B-03 Manual De Instrucciones página 9

SAFETY INFORMATION
• After finishing the cut, release the switch, hold the saw head down and wait for the
blade to stop before removing the cut-off piece. Reaching with your hand near the
coasting blade is dangerous.
• Hold the handle firmly when making an incomplete cut or when releasing the switch
before the saw head is completely in the down position. The braking action of the saw
may cause the saw head to be suddenly pulled downward, causing a risk of injury.
Additional Safety Warnings for Miter Saw
WARNING
• The use of this tool can generate and/or disburse dust, which may cause serious and
permanent respiratory or other injury. Always use protection appropriate for the dust
exposure. Direct particles away from the face and body.
• Know your power tool. Read the Operator's Manual carefully. Learn the applications
and limitations, as well as the specific potential hazards related to this tool. Following this
rule will reduce the risk of electric shock, fire or serious injury.
• Before beginning power tool operation, always wear safety goggles or safety glasses
with a side shield and a full face shield when needed. We recommend a Wide Vision
Safety Mask for use over eyeglasses or standard safety glasses with side shields. Always
use eye protection which is marked to comply with ANSI Z87.1.
• Only use recommended saw blades with specified size and arbor.
• Do not use with any abrasive wheels.
• Protect your lungs. Wear a face mask or a dust mask if the operation is dusty.
• Protect your hearing. Wear appropriate personal hearing protection during use. Under
some conditions and duration of use, noise from this product may contribute to hearing loss.
• All visitors and bystanders must wear the same safety equipment that the operator of the
saw wears.
• Always check the tool for damaged parts. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine whether it will operate
properly and perform its intended function. Check for misalignment or binding of moving
parts, broken parts, and any other condition that may affect the tool's operation. A guard or
other part that is damaged should be properly repaired or replaced by a qualified person.
• Save these instructions. Refer to them frequently and use them to instruct others who may
use this tool. If someone borrows this tool, make sure they have these instructions also.
9