Care And Maintenance - Kobalt KMS 0724B-03 Manual De Instrucciones

CARE AND MAINTENANCE

All maintenance should only be carried out by a qualified service technician.
Cleaning
WARNING
• Before cleaning or performing any maintenance, remove the battery pack from the miter
saw. For safe and proper operation, always keep the tool and its ventilation slots clean.
• Always wear safety goggles or safety glasses with side shields when blowing dust. If
operation is dusty, also wear a dust mask.
• Always use only a soft, dry cloth to clean your miter saw; never use detergent or alcohol.
Lubrication
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant
for the life of the unit under normal operating conditions. Therefore, no further lubrication is
required.
Some areas will require infrequent lubrications. You will need to apply:
a. Automotive oil directly to the slide bars.
b. Light oil or pressurized light spray oil to the arm pivot shaft.
c. Light oil or pressurized light spray oil to the torsion spring.
WARNING
• To ensure safety and reliability, all repairs should be performed by a qualified service
technician at an authorized service center to avoid risk of personal injury.
• When servicing, use only identical replacement parts. Use of any other part may create a
hazard or cause product damage.
32