Sticker On The Product; Product Information; Declaration Of Conformity; Safety Instructions - Hilti PM 40-MG Manual De Instrucciones Original

This symbol is intended to draw special attention to certain points when handling the product.
1.3

Sticker on the product

Laser information
Laser class 2 based on standard IEC60825-1 / EN60825-1:2007 and compliant with CFR
21 § 1040 (Laser Notice 50).
Do not look straight into the laser beam.
1.4

Product information

Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be specifically informed about the possible hazards. The
product and its ancillary equipment can present hazards if used incorrectly by untrained personnel or if used
not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Multi-line laser
Generation
Serial no.
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916 Kaufering, DE
2 Safety
2.1

Safety instructions

In addition to the warnings given in the various sections of these operating instructions, the following
points must be strictly observed at all times. The product and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when used not as directed.
▶ Keep all safety instructions and information for future reference.
▶ Check the accuracy of the tool before use and several times during use.
▶ Stay alert, watch what you are doing and use common sense when operating the tool. Do not use the
tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention
while operating the tool may result in serious personal injury.
▶ Tampering with or modification of the tool is not permitted.
▶ Do not render safety devices ineffective and do not remove information and warning notices.
▶ Keep children and other persons away from the area while the tool or appliance is in use.
▶ Take the influences of the surrounding area into account. Do not use the tool where there is a risk of fire
or explosion.
▶ The laser plane should be well above or well below eye height.
▶ You must check the accuracy of the device after it has been dropped or subjected to other mechanical
stresses.
▶ To achieve maximum accuracy, project the line onto a vertical, flat surface. When doing so, set up the
tool at 90° to the surface.
▶ Keep the laser exit aperture clean to avoid measurement errors.
▶ Observe the information printed in the operating instructions concerning operation, care and maintenance.
▶ When not in use, tools must be stored in a dry, high place or locked away out of reach of children.
▶ Observe the national health and safety requirements.
12 English
PM 40-MG
01
2171411
*2171411*