Electrical Connection - CASO DESIGN Master E2 Manual De Instrucciones

13.6 Electrical connection

caso Master E2
In In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the
electrical connection:
• Before connecting the device, compare the connection data
(voltage and frequency) on the rating plate with those of your
electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out
switch.
• The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a cross-
section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been
installed under the oven or over hot or sharp surfaces.
The electrical safety of the device is only guaranteed if the device
is connected to a properly installed protective conductor system.
Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that
are caused by a missing or damaged protective conductor.
50