Ingeteam
1.
Remove the fastening plate as shown in the following figure:
2.
Drill holes in the wall with a suitable bit for the fastening elements to be used to secure the plate to the
wall later.
3.
Fix the plate using fastening elements that are appropriate for the wall onto which it is to be installed.
The diameter of the holes of the plate are 0.31 in (8 mm).
a = 8.66 in (220 mm).
4.
Suspend the unit from the plate by fitting the slats in the openings on the back of the unit.
24
ABO2012IQM01_ - Installation and Operation Manual
Installing the unit