Opening And Closing The Housing - Ingeteam INGECON SUN 40TL U M480 Manual De Instalacion Y Uso

Ingeteam
It is mandatory to follow the order described above. Do not switch on the power until you have made
all the connections and closed the unit.

6.3. Opening and closing the housing

To access the inside of the unit, remove the front screws highlighted in gray in the following figure and open the
cover as shown below.
After making the different connections explained in the sections below, close the unit before starting it. To close
the housing, tighten the aforementioned screws, applying a torque of 53.1 lb.in (6 Nm).
Check that the unit is correctly closed before starting up the unit.
Section "2.10. Description of cable inlets" indicates the range of cable diameters valid for each
cable grommet.
26 ABO2012IQM01_ - Installation and Operation Manual
Installing the unit