Hergom ARANDA Instrucciones Para La Instalación, Uso Y Mantenimiento página 61

Leave sufficient length of cable to be able to pull it out and replace in the
event of any maintenance work. Before installing the oven, check that the
electric installation is working correctly.
LIGHT REPLACEMENT
This operation is carried out on the inside of the oven.
Unscrew the light shade and remove the worn bulb (screw tip).
Replace it with another of the same thermal characteristics that can be
bought from specialist shops or from the supplier of your range cooker.
Do not forget to replace the protective shade.
E.- UNPACKING
Inside the log tray (only in the case of models with lining) you will
find two screws that fix the lining to the palet. The said screws must be
removed before installing.
F.- DISSEMBLING THE ARANDA OVEN IF REQUIRED
TO PASS THROUGH A DOORWAY INSIDE A HOUSE.
1. Remove the top section; the roof is located on top of the structure; it
can be removed by pushing it upwards.
2. Remove the oven doors; open the right-hand door and free the hinges
by pushing the door upwards. Do the same with the left-hand door.
Study the door-removal drawing for the Santacruz model oven.
3. Remove the fireplace door; follow the same instructions as in the case of
the Santacruz model oven door.
4. Remove the lower skirting board; you will find two M-5 Allen head
screws at either end, which must be removed using a Num. 3 Allen Key.
Once you have removed the screws, slide the front part of the skirting
board forward until it comes free. Do the same with the rear section.
Fig.-12
61