Electrical Hook-Ups; Wiring Diagram; Commissioning; Operation And Use - Sime ECOMAXI 90 ErP Manual De Instalación, Uso Y Mantenimiento

Installation, use and maintenance manual
5.6

Electrical hook-ups

The product is supplied already wired. It is powered
via a cable and plug/socket (Fig. 10 and Fig. 11).
WARNING: the electric power supply the
appliance is connected to must be
protected by a suitable circuit breaker.
Fig. 10 – User socket
5.7

Wiring diagram

Fig. 12 – Wiring diagram
Fig. 11 – Appliance plug
Probe 1: upper probe
Probe 1: lower probe
Probe 3: evaporator probe
Digital 1: NOT USED
Digital 2: solar panel input
(OPTIONAL)
6

COMMISSIONING

WARNING: check that the appliance has
been connected to the earth wire.
WARNING: check that the mains voltage
corresponds to the voltage shown on the
appliance data plate.
To commission the appliance, proceed as follows:
 Fill the boiler using the inlet valve and check
that there is no leakage from the gaskets and
connectors.
 Do not exceed
specified under "general technical data";
 Check that the safety devices in the hydraulic
circuit are functioning;
 Connect the plug to the power socket;
 When the plug is plugged in, the boiler is in
stand-by mode, the display is off and the ON
button lights up;
 Press the ON button (see section 7.1.3.1) and
the appliance is activated in ECO mode
(factory default).
7

OPERATION AND USE

The product is managed through a user interface
which allows you to:
 set the operating mode;
 change the operating parameters;
 view and manage any alarms;
 check the status of the resources.
Hereinafter, "switching on" should be
understood as the passage from stand-by
mode to ON
"switching off" should be understood as
the passage from ON mode to stand-by
mode.
Hereinafter, the
procedure" should be understood as
referring to specific appliance procedures
as described in the "advanced set-up"
section.
7.1

USER INTERFACE

The user interface (Fig. 13) allows you to check and
adjust appliance operation. It is equipped with a
display and the following buttons:
 On/Stand-by button;
 SET button;
 DOWN button;
 UP button.
MANUAL CODE: 6328406
the maximum pressure
mode, and the term
term "advanced
Page 44 / 124