Buttons And Interface; Operation - Sime ECOMAXI 90 ErP Manual De Instalación, Uso Y Mantenimiento

Installation, use and maintenance manual
Display
SET On/Stand-by
button button
Fig. 13 – User interface
7.1.1

BUTTONS AND INTERFACE

7.1.1.1 On/Stand-by button
Use this button to:
 turn the product on (ON status);
 put the product in stand-by mode (in this
mode, the appliance
automatically according to specific time
settings and automatically activate the anti-
legionella and defrosting functions).
When the appliance is powered up, it
keeps the same status as when the power
supply was disconnected.
7.1.1.2 [SET] button
Use this button to:
 confirm a selection or value set.
7.1.1.3 [UP] button
Use this button to:
 scroll up through the list of parameters;
 increase the value of a parameter.
7.1.1.4 [DOWN] button
Use this button to:
 scroll down through the list of parameters;
 decrease the value of a parameter.
7.1.1.5 Interface display
The interface display (Fig. 14) shows the:
 control temperature;
 alarm/error codes;
 status notifications;
 operating parameters.
DOWN UP
button button
can operate
Fig. 14 – User interface display (mono-boiler model)
Compressor
LED
Defrosting LED
MF LED
Fan LED
Maintenance
LED
Alarm LED
Degrees
Celsius LED
Degrees
Fahrenheit LED
On/Stand-by
LED
7.1.1.6 Warnings
Loc The keypad is locked (see section 7.1.3.3).
dEFr Defrosting is in progress. Other functions cannot
be activated.
Anti The Anti-legionella function is in operation.
ObSt The Overboost function is in operation.
ECO The Economy function is in operation.
Auto The Automatic function is in operation.
7.1.2

OPERATION

7.1.2.1 Operating modes
The appliance can operate in the following
modes:
MANUAL CODE: 6328406
If it is on: the compressor is
active.
If it is flashing:
The compressor is in

the process
switching on.
 The operating setpoint is
being modified;
If it is on: defrosting is in
progress
If it is on: the electrical resistor
on the boiler is active
If it is on: the fan is active
If is on: the air filter requires
maintenance
If it is on: check the list of
alarms and follow
procedure indicated in this
manual
If it is on: the unit
measurement for temperature
is degrees Celsius
If it is on: the unit
measurement for temperature
is degrees Fahrenheit.
If it is on: the device is in
stand-by mode.
If it is flashing: the appliance
has been switched on/off
manually while in automatic
timed on/off mode.
Not used
Page 45 / 124
of
the
of
of