Unpacking; Assembling The Side Brush - Lavorwash SWL 700 ET Manual De Istrucciones

UNPACKING:

Having eliminated the outer packaging, free the machine from the pallet as follows:
1) Release the front wheel brake
2) Remove the sticky tape Detail C blocking the handlebar
3) Open the bin Detail A and pull out the two handlebar supports Detail B Fig.1
4) Screw the handlebar supports Part. B into the holes Part. E Fig. 1
5) Screw the ends of the handle into the holes Detail D on the supports as shown in Fig.1/B
6) Take the machine off the pallet: according to the machine weight, written on the CE label, this can be
different ways:
a) With the aid of one or more people provided with gloves, lift the machine, holding it by handle at the
front, and stand it on the ground.
b) With the aid of a slanting board (not longer than 80 cm not to damage the dust flaps) placed against the
narrowest side of the bench, slide the machine down until the floor.
IMPORTANT: Check that the machine has not been damaged. In the case of apparent faults, do not attempt to
use the machine and inform the supplier or the manufacturer.
_______________________________________________________________________________________
IT IS DUTY OF THE USER TO ENSURE THAT THE WASTE PACKAGING IS DISPOSED OF
AND DESTROYED ACCORDING TO THE SPECIFIC REGULATIONS.
_________________________________________________________________________________________

ASSEMBLING THE SIDE BRUSH:

1)
Take the side brush Detail 2 Fig. 2 out of the bin Detail A Fig. 1
2)
Unscrew and remove the three bolts Detail 1 Fig. 1; assemble the brush so that the three pins fit into the holes
Detail 3 Fig. 2
3)
Replace the three bolts Detail 1 and screw on tightly to block the brush.
4)
Once assembled, the side brush makes contact with Detail 2 Fig. 2 blocking the pulley where to place the elastic belt
Detail 5 Fig. 1
5)
Pull the belt Detail 5 forwards and fit it into the plastic pulley Detail 4.
6)
Unscrew the screws Detail 6: the purpose of these screws is to keep the belt taut while assembling the brush. Once
the brush has been assembled these screws are no more needed.
7)
Secure the cover Detail 1 Fig. 3 using the three screws Detail 2 Fig. 3.
CHAPTER 4 - PERMITTED ENVIRONMENTAL CONDITIONS
FOR THE ENDOTHERMIC VERSIONS:
MINIMUM WORKING TEMPERATURE
FOR THE ELECTRIC VERSIONS:
MINIMUM WORKING TEMPERATURE
IMPORTANT: Do not use or leave parked with temperatures above +45° C (+113° F).
CHAPTER 5 – PERMITTED AND FORBIDDEN USES
PERMITTED USES:
The SWL 700/900 – SW 2600/SW 3700 sweeping machines are designed for cleaning ground surfaces under the following
conditions: types of material to be swept up from ground: machining residues, dust, grit, dirt in general; types and features
of working surfaces (ground): hard, flat and compact surfaces such as: asphalt, concrete, wood surfaces, metallic surfaces,
ceramics, marble, smooth or rusticated plastic materials fibre or synthetic (to avoid electrostatic charges on these surfaces,
natural fibre brushes are essential.) cut moquette; type of environment: closed environments (electric versions), open
environments (endothermic versions).
FORBIDDEN USES:
MAXIMUM WORKING TEMPERATURE
MAXIMUM WORKING TEMPERATURE
- 28° C
+ 38° C (+ 100° F)
- 20° C
+ 40° C (+ 104° F)
Pag. 28
done
(- 18,4° F)
(- 4° F)
in