Chapter 11 Starting And Stopping - Lavorwash SWL 700 ET Manual De Istrucciones

all used in this way it will always be fresh.
_________________________________________________________________________________________
__
STORE THE FUEL IN A FRESH AIRY PLACE, AWAY FROM SOURCES OF HEAT AND OUT OF
REACH OF CHILDREN.
_________________________________________________________________________________________
SPECIFIC CHECK FOR MACHINES POWERED BY BATTERY SPECIFIC CHECK FOR MACHINES POWERED BY BATTERY
Check if the battery contains the sulphuric acid solution and if it is charged.
If not, proceed as follows:
Carefully read the chapter "Safety rules and regulations", which specifies the risks involved with filling the
Acquire the following instruments and personal protections: Safety glasses, protective gloves, 1 pair of scissors,
 Use the scissors to cut off the end of the plastic container holding the sulphuric acid solution and pour it into the
transfer container.
 Remove the cap to the chambers of the battery elements.
 With the aid of the funnel, pour in the solution until it reaches the level shown on the outside of the battery.
 Wait at least 12 hours leaving the battery inactive and then, if necessary, top up the solution bringing the levels, of the
various elements to the same conditions.
 Carefully read, in the chapter "Safety rules and regulations", the risks involved in charging or discharging the battery.
 Charge the battery.
_________________________________________________________________________________________
BEFORE STARTING THE MACHINE, IT IS INDISPENSABLE TO HAVE READ THE PREVIOUS
CHAPTERS.
_________________________________________________________________________________________
SPECIFIC SEQUENCE FOR MODELS WITH ENDOTHERMIC ENGINES
SPECIFIC SEQUENCE FOR MODELS WITH ENDOTHERMIC ENGINES
STARTING:
1 - Turn the STOP control clockwise to position "1"
2 - Open the fuel cock
3 - Set the speed control lever to "S" (start)
4 - Close the "starter" lever
> If the engine is already warm or in hot weather, pull the starter halfway out or keep it fully open
> If the engine is cold or in cold weather, close the starter.
5 - Pull the self-winding handle slowly until it offers resistance. This point marks the start of compression. Return the
handle to its original position and pull it sharply. Do not pull the cable out of the guide. Start the engine and return
the self-winding handle to its original position without letting it go sharply.
6 - Start the engine and open the starter lever gradually leaving it fully open. Do not open the starter lever fully if the
engine is still cold or in cold weather as the engine might stall.
RUNNING:
1 - Once the engine is running return the accelerator lever to the low speed position " L " and warm the engine for a few
minutes. Gradually move the accelerator lever towards the high speed position " H " until the required speed is
reached.
IMPORTANT: If there is no need to keep the engine accelerating, slow it down gradually by moving the
accelerator lever to the idle running speed: this will reduce fuel consumption and prolong the engine life.
TURNING THE ENGINE OFF:
1 - Move the accelerator lever to Minimum and keep the engine running for 2-3 minutes before turning it off.
2 - Turn the STOP control anticlockwise to " O ".
3 - Close the fuel cock
4 - Pull the self-winding handle slowly and return it to its original position until the point of resistance.
elements with the sulphuric acid solution
1 receptable for the transfer (clean), 1 funnel (clean).
CHAPTER 11 – STARTING AND STOPPING
Pag. 33