Battery; Charging Battery - Nobles SPEED SCRUB 15 Manual Del Operario

BATTERY

Your machine is equipped with either a 12V lithium- ion
battery or a 12V sealed AGM lead acid battery. The
battery does not require any maintenance other than
routine charging.
12V Lithium- ion Battery
To convert a machine with an AGM battery to a
Lithium- ion battery or a Lithium- ion battery to an AGM
battery, a battery conversion kit is required.
Do not exchange battery types unless conversion kit is
installed, machine and battery damage may result.
9008689 - AGM to Lithium- ion Battery Conversion Kit
9008688 - Lithium- ion to AGM Battery Conversion Kit

CHARGING BATTERY:

Only use the battery charger that is approved and
supplied by Tennant (Fig. 21).
FOR SAFETY: When servicing machine, the use of
incompatible battery chargers may damage battery
and potentially cause a fire hazard.
Lithium- ion Battery Model -
HB250- 12 Battery Charger
Nobles Speed Scrub 15 Battery (03- 11)
12V AGM Sealed
Lead Acid Battery
FIG. 20
AGM Battery Model -
CBHD1- 12 Battery
Charger
FIG. 21
For battery charger operating instructions, refer to the
User's Manual supplied with the battery charger. The
charger's User's Manual should remain with the battery
charger at all times.
For Lithium- ion battery models, recharge battery after
every use even if only slightly discharged.
For AGM battery models, only recharge battery after 20
minutes of use or more. This will prolong the life of the
battery.
FOR SAFETY: Do not operate machine if battery
emits an unusual odor, leaks any substance or
becomes excessively hot.
To Charge Battery:
1. Transport the machine to a ventilated area.
2. Park the machine on a flat, dry surface and turn the
main power switch to the off position.
3. Remove the charging receptacle cover at the rear
of the machine and plug the charger's DC cord into
the receptacle (Figure 22).
4. Connect the charger's AC power supply plug into a
properly grounded receptacle.
NOTE: The machine will not operate once the battery
charger is connected.
5. The charger will start automatically and begin the
charging process until battery is fully charged. The
charger's three LEDs will display solid when fully
charged.
Maximum Charging Cycle:
3 hours - Lithium- ion battery
8 hours - AGM battery
NOTE: If charger is left plugged in after charging is
complete, the charger will go into a maintenance mode
and keep battery fully charged.
ENGLISH
FIG. 22
11