Battery Maintenance; Transporting Machine; Storing Machine; Recommended Stock Items - Nobles SpeedGleam Serie Manual Del Operador

BATTERY MAINTENANCE

WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and
open flame away. Keep battery compartment open
when charging.
FOR SAFETY: When servicing machine, wear
protective eyewear and gloves when handling
batteries or battery cables. Avoid contact with
battery acid.
1. Always follow proper charging instructions
(see CHARGING BATTERIES).
2. Each week after charging, check the fluid level (A)
in each battery cell of all batteries. The level
should be 1cm (3/8 in) from bottom of sight tubes
(B). If needed, add distilled water to proper level.
DO NOT overfill (Figure 32).
B
FIG. 32
3. Keep the battery tops and terminals clean and dry.
a. Mix a strong solution of baking soda and water
(Figure 33).
FIG. 33
b. Brush the solution sparingly over battery tops,
terminals, and cable connectors.
NOTE: Do not allow baking soda solution to enter
battery cells.
c. Use a wire brush to clean the terminals and
cable connections.
d. After cleaning, apply a coating of clear battery
post protectant to the terminals and cable
connections.
4. Check for loose or worn cables. Replace if worn.
Nobles SpeedGleam/Plus (1–02)
A
Home Find... Go To..

TRANSPORTING MACHINE

When transporting the machine by use of trailer or
truck, be certain to follow the tie–down procedures
below:
ATTENTION: Tilt the machine back on its rear
wheels when loading and unloading to prevent
dust skirt damage.
1. Load the machine using a recommended loading
ramp.
NOTE: When lifting the machine, you must remove
the batteries.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
2. Position the front of the machine up against the
front of the trailer or truck bed.
3. Place blocks behind the main wheels.
4. Place tie–down straps over the top of the machine
and secure straps to the floor. It may be
necessary to install tie–down brackets to the floor
of your trailer or truck.
NOTE: Do not use control grips to secure machine for
transporting.
ATTENTION: Do not transport machine tilted back,
battery acid may leak.

STORING MACHINE

Store machine in a dry area in the upright position.
ATTENTION: Do not store machine tilted back,
battery acid may leak.
ATTENTION: Do not expose to rain. Store indoors.

RECOMMENDED STOCK ITEMS

Refer to the Parts List section in this manual for
recommended stock items. Stock Items are clearly
identified with a bullet preceding the parts description.
See example below:
OPERATION
15