Control Panel; Appliance Functions; Safety Functions; Memory Function - UFESA PN5000 Manual De Instrucciones

Control panel

15
LCD display
After connecting the bread maker to power, the display
shows a symbol "1 3:25". The number "1" indicates
the selected program, the symbol "3:25" indicates the
duration of the selected program. The position of the
two markings indicates the selected browning level
and the weight. The default setting after switching
the appliance on is "superior weight" (1000 g) and
"medium browning level" (medio). Information
concerning the baking process will be shown on the
display while the appliance is operating. The time
shown on the display will gradually decrease. Other
information concerning the timer (tiempo), preheating
(precalentar), kneading (amasar), pause (reposo),
dough rising (fermentar), baking (cocer), the keep
warm function (templar) and the end of the program
(fin) will also appear on the display.
16
start/stop button – starts and stops the program.
17
timer – sets the clock.
18 dorado button – is used to set the desired
browning level.
19
menu button – is used to select the program.
20
carga button – setting the weight according to the
description below.

Appliance functions

Buzzer function
The buzzer goes off:
● When pressing the program buttons.
● During operation a sound signal will come off
informing and reminding the user to add nuts, sunflower
seeds, raisins etc.
● When the end of the program is reached.
After pressing the start/stop button you
can turn off the sound. In order to do this
press and hold both of the timer buttons
for approx. 2 seconds. If you press and hold
both of the timer buttons for a second time, you
will hear a sound signal informing that sound is
on again.

Memory function

If there is a brief power cut of up to approximately
15 minutes the program position is stored and the
machine can continue from this position when power
is restored. This is possible only if the program was
stopped before the kneading phase was reached.
Otherwise you will have to start from the beginning.
Auto dosing of loose additives
Within the cover of this device there is a dispenser of
bulk additives (4). Loose ingredients, such as fruits,
nuts, raisins, grains, may be added to baking. In order to
this, you have to place a given product in the dispenser
before the baking process (details provided in
paragraph 4). The device automatically adds products
to a cake in an appropriate moment during cake mixing
and kneading.
Additional ingredients may also be added to sprinkle
the upper part of the cake. It is best to place these
ingredients into the dispenser for loose ingredients
ca. 30 minutes before the end of the baking process.
Adding the additional ingredients shall be indicated by
a sound signal. Programs in which this feature is used,
are described in tables referring to phases of device
operation.

Safety functions

If the temperature of the appliance is still too high
to start a new program after using the appliance
previously, the symbol E 01 will appear on the display
after you press the start button again, you will also
hear a beep. In such a case, press and hold the start/
stop button until the E 01 symbol disappears from the
display and the basic setting appears on the display.
Remove the baking tin and wait for the appliance to cool.
The cocer program can be started
immediately even if the appliance is
still hot.
Operating instructions
1
Insert the baking tin.
The baking tin is covered with a non-stick layer. Place
the baking tin exactly in the middle of the base inside
the appliance. Turn gently the container clockwise until
it is blocked.
The handle is hot after baking. Use pot
holders.
2
Insert the kneading peg.
Insert the kneading peg by placing the shank of the
baking tin in the opening of the kneading peg.
B