Operation
Remote Control and Keyless Entry
Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote
controls are NOT compatible, see page 40 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Press and immediately release the Learn button.
2. Remote Control: Press and hold the button on the remote control that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps for programming additional remote controls or keyless entry devices.
1
2
OR
?
To watch a video, go to tinyurl.com/lcsf6xt
®
HomeLink
If your vehicle is equipped with HomeLink, a Compatibility Bridge
certain vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
LEARN Button
LEARN LED
?
?
?
PIN
TM
(not included) may be necessary for
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
1. Press and hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes
are now erased. Reprogram any accessory you wish to use.
35
®
enabled accessories)