Start Up; Cutting Height Adjustment - Truper ROU-NX3 Manual De Instrucciones

Additional Base Assembly
• The additional base (A) is fundamental to protect the
work piece while cutting and to get a finer job.
CAUTION • When using bits bigger than 1
Remove the additional base and keep in mind the finish
will be rough.
Parallel Guide Assembly
• Slide the parallel guide rods (B) into the orifices (C)
in the router base up to the required depth and tighten
the blocking levers (D).

Cutting Height Adjustment

CAUTION • Before adjusting height please switch
off and disconnect the router from the power source.
• Set the router base onto a flat and leveled surface with
the back of the tool facing you.
• Open the bracket (E) in the fixed base.
• With the cutting bit already assembled, press de height
adjusting button (F) and lower the cylinder until the bit is
very close to the surface where the router is supported.
• Turn the height fine adjusting knob (G) until the bit
barely touches the surface where the router is supported.
• Without moving the fine adjusting knob turn the
graduated ring (H) until zero "0" is aligned with the mark
( I ) in the fixed base.
• Set the router on top of two discarded and leveled work
pieces. Set them in a way that allows the bit to be lowered
under the additional base.
• Turn the height fine adjustment knob (G) clockwise to
lower the bit down to the cutting depth desired. Turn the
dial in a counterclockwise direction to lift the bit.
• The graduated ring (H) increases each 1/64". Half a turn
clockwise of the fine adjusting knob (180°) lowers the bit
1/16" below the additional base. A full turn (360°) lowers
1/8". The system allows up to 7 full 360° revolutions
clockwise to lower the bit 7/8".
• Once the cutting depth is set, close the bracket (E) in the
fixed base.
8
ENGLISH
Assembly
1 / ".
4

Start Up

G
H
I
F
G
H
F
A
C
B
D
E
E