Spool Gun; T3/M3; T1/T3/M1/M3; Co2 - GYS M1 AUTO 208/240V USA Manual De Instrucciones

Translation of the original instructions
GAS CONNECTION (FIG II)
Connect the manometer (flowmeter) to the gas bottle (manometer not supplied with the product).For use with one
or two bottles of gas.
To connect two bottles of gas to three torches, split the pipe into 3 pieces and attach a 3-way "Y" connector. (fig II-C )
To link a single bottle of gas with 3 torches, cut the pipe into 4 pieces and attach two 3-way "Y" connectors.
Connect each bottle to the solenoid valves in the following order:
-T1 GYS AUTO solenoid valve to the top left (fig II-B:12)
-Spool gun solenoid to the top right (fig II-B:16)
-T3 GYS AUTO solenoid valve to the bottom (fig II-B:14)
To avoid any gas leaks, always use the collars supplied with the product.
PROCESS OF REELS AND TORCHES ASSEMBLY (FIG 4)
Open the device trapdoor.
- Place the reel on the driving pin (fig IV-2) of the reel support.
- Adjust the reel brake (fig IV-3) to avoid the reel inertia tangling the wire when welding stops. In general, do not tighten
too much!
- The electrical roller (fig IV-4) is a double groove roller (0,6/ 0,8 and 0,8/1). The indication on the visible side of the
roller is the diameter in use. For a 0,8 wire, use the 0,8 groove.
- For the first use:
- Release the fixing screw of the wire guide.
To set the adjusting knob of the pressing rollers (fig IV-5), proceed as follow: loosen the knob fully, start the motor by
pressing the torch trigger, tighten the adjustment knob whilst pressing the trigger. Bend the wire where it comes out of
the nozzle and hold it in place to stop its progress. The setting is correct when the guide roller slides over the wire even
when it is blocked at the end of the torch. A common adjustment is the rollers command (fig IV-5) on the scale 3 for
steel and 2 for aluminium.Nb: for the aluminium wire put a minimum pressure in order not to crush the wire.
CHOICE OF REELS
Possible settings :
Wire type
Ø 300
steel Ø 200
Ø 100
Ø 200
stainless
steel
Ø 100
Ø 200
CuSi3
Ø 200
CuAl8
Ø 300
Alu
AlMg5
Ø 200
Ø 100
AlSi5
AlSi12 Ø 100
* Consider Teflon sheath and special aluminium contact tip
20
M1 - T1 & M3 - T3 GYS AUTO
Torch 1 Torch 2

Spool gun

T1,T3,M1,M3

T3/M3

T1/T3/M1/M3

x
x x
x x
x x
x x
x*
x* x*
Gas
argon
x +

CO2

x
pure
argon
x
x
EN