Malaguti DRAKON 50 Manuel Du Propriétaire página 138

C) STAND-BY (sub-menu)
When this image appears on the display,
you can switch the sub-menu display format
(bar graph) from V-batt to RPM and vice versa
by pressing the MODE within 3 seconds. If
this command is not given within 3 seconds,
the instrument board switches to the 0-40
function.
D) FUNCTION 0-40
It shows acceleration from 0 to 40 km/h.
This function is automatically reset after 15
seconds. The function can be called up
again by starting the vehicle.
E) TIME FUNCTION
It shows the current time. To set the time,
hold the MODE button down until the sub-
menu (bar graph) disappears, then press
the MODE button again to actually change
the time setting. The increase will be slow
for the first ten units and then become faster.
To return to the normal display, do not press MODE for at least 3".
If power is disconnected, this function will be automatically reset.
The setting operation must be thus repeated. This operation must
be performed with the vehicle at a standstill.
INSTRUMENT AND CONTROL FUNCTION
F) LAP FUNCTION
G) AVE FUNCTION
H) TD FUNCTION
ENGLISH
This is the chronometer. Press the MODE
button once to START the chronometer (all
previous data are reset); press again to
STOP. To use this function, press the MODE
button until you relocate the LAP function.
Values are given in MIN and SEC.
This indicates the average speed in mph.
The calculation does not include stops
(speed = 0). To reset, hold the MODE button
down when the vehicle is at a standstill until
a '0' appears on the display.
This indicates the partial distance. To reset,
hold the MODE button down with the vehicle
stationary.
3
15