Adjusting The Device; Terminal Resistor - ABB M2233 Serie Manual De Instrucciones

ABB-Welcome
Pos : 70 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Geraeteei nstellungen @ 18\mod_1302768847744_15.doc x @ 103548 @ 2 @ 1
4.4

Adjusting the device

Pos : 71 /DinA4 - Anl eitungen Onli ne/Ueberschriften/3./Absc hlus s widerstand @ 19\mod_1321958079906_15.doc x @ 110083 @ 3 @ 1
Pos : 72 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Absc hl uss widerstand setzen 83220-AP- xxx @ 19\mod_1310723392369_15.doc x @ 107841 @ @ 1
4.4.1

Terminal resistor

Fig. 35: Terminal resistor
Pos : 74 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Master/Sl ave Schalter s etz en 83220-AP- xxx @ 19\mod_1310723320966_15.doc x @ 107833 @ @
No. Functions
1 Station
Select switch to set the address of default outdoor station.
2 X10 X1
Select switches to set the address (0-99) of the indoor station.
Setting hundreds ,see Chapter 4.2.12.15 "setup".
3 Master/slave function
Only one indoor station in each apartment should be set as "master"
(Switch should be set as "M/S on.") All additional indoor stations in the
same apartment must be set as "slave" (Switch should be set as "M/S
off.")
4 Terminal resistor
In video installations or mixed audio and video installations, the switch
should be set as "RC on" on the last device of the line.
|
— 54 —