Adjusting The Device - ABB M2303 Manual De Instrucciones

ABB-Welcome
Pos : 70 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Geraeteei nstellungen @ 18\mod_1302768847744_15.doc x @ 103548 @ 2 @ 1
4.4

Adjusting the device

Pos : 71 /DinA4 - Anl eitungen Onli ne/Ueberschriften/3./Absc hlus s widerstand @ 19\mod_1321958079906_15.doc x @ 110083 @ 3 @ 1
Pos : 72 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Absc hl uss widerstand setzen 83220-AP- xxx @ 19\mod_1310723392369_15.doc x @ 107841 @ @ 1
Fig. 40:
Pos : 74 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Master/Sl ave Schalter s etz en 83220-AP- xxx @ 19\mod_1310723320966_15.doc x @ 107833 @ @
1. Station
Jumper to set the address of default outdoor station
2. X1
Jumper to set the address of the guard unit
3. Master/slave function
Only one guard unit in each building should be set as "master." (Jumper should be
set as "M/S on".) All other guard units in the same building must be set as "slave."
(Jumper should be set as "M/S off".)
4. Terminal resistor
In video installations or mixed audio and video installations, the jumper must be
set as "RC on" on the last device of the line.
5. a b = Bus connection
= Doorbell connection
DC GND = Additional power supply
6. USB connector
USB connector to PC to download/upload the configuration, e.g. download the
contact lists.
Pos : 75 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Steuermodul e - Onli ne-D okumentation (--> F ü r all e D okumente <--)/++++++++++++ Seitenumbruc h ++++++++++++ @ 9\mod_1268898668093_0.doc x @ 52149 @ @ 1
Pos : 76 /DinA4 - Anl eitungen Onli ne/Ueberschriften/1./Tec hnisc he D aten @ 18\mod_1302615863001_15.doc x @ 103416 @ 1 @ 1
|
— 47 —