Fitting The Polishing Mandrel; Replacing The Grinding Disc - Parkside PMDS 100 B1 Manual Del Usuario

■ Never press on the spindle locking button
while the grinding disc
♦ Switch the appliance on by pressing the
ON/OFF switch
♦ Set a speed suitable for the work using the
speed control .
♦ Switch the appliance off by pressing the
ON/OFF switch

Fitting the polishing mandrel

WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
■ WARNING! Never use grinding discs
on the brush side of the machine!
CAUTION!
♦ Never press on the spindle locking button
while the grinding disc
♦ Remove the cap
♦ Press the spindle locking button
shaft.
♦ Screw in the polishing mandrel
♦ Screw the desired polishing tool
or onto the polishing mandrel
4g
♦ Completely cover the grinding disc
the protective cover
♦ After finishing work, remove the polishing man-
drel by working in the reverse order.
NOTE
► Do not apply any lateral pressure to the brushes.
PMDS 100 B1
, is turning
4a 4b
.
again.
, is turning.
4a 4b
.
to block the
(see fig. B).
, ,
4c 4d 4e
(see fig. B).
,
4a 4b
(see fig. B).

Replacing the grinding disc

WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
WARNING!
► The grinding disc
any larger than the prescribed diameter.
♦ Unscrew the fixing screw
and remove the cover (see fig . C).
♦ Never press on the spindle locking button
while the grinding disc
♦ Press the spindle locking button
shaft.
♦ Unscrew the union nut
using a monkey wrench.
♦ Take the tension disc
disc ,
4a 4b
fig. C).
♦ Place a new grinding disc on the centring flange
and push this onto the shaft
♦ Screw the tension disc
back onto the shaft
♦ Keep the spindle locking button
,
4f
and re-tighten the union nut
using
WARNING! RISK OF INJURY!
► Never use a grinding disc
protective cover.
♦ Replace all side covers and fasten them securely
in place by tightening the fixing screws
■
, used may not be
4a 4b
on the side cover
, is turning.
4a 4b
from the appliance
, union nut
and the centring flange
and the union nut
.
.
,
4a
4b
Direction of rotation of the tool!
GB │ IE
to block the
, grinding
off (see
(see fig. C).
pressed in
without the
firmly.
│
17 ■