Modifying Setup - Grundfos Oxiperm Pro OCD-162 Instrucciones De Instalación Y Programación

9.7 Modifying setup

Setup is selected as follows:
1. "main menu > setup" > [OK].
main menu
setup
language
date/time
code function
display
Fig. 15 Structure of the "setup" menu for operators
Other menus can only be accessed with the
Note
Note
service code.
9.7.1 Changing the language
1. "main menu > setup" > [OK].
2. "language" > [OK].
3. Select the operator language > [OK] > [Esc].
9.7.2 Changing the operator code
1. "setup" > "code function" > [OK].
code function
change code
delete code
2. "change code" > [OK].
A request for the old code appears:
code function
old code: 0
3. Press the [Up] button to set the old code, confirm with [OK].
code function
new code: 0
4. Press the [Up] button to set the new code (maximum 9999),
confirm with [OK].
The new code is set. The code request now appears before all
submenus that can be accessed by operators.
Delete code
1. "delete code" > [OK].
The code setting is deleted. Access is now only possible with the
factory-set operator code 0000.
34
9.7.3 Setting the time
1. "main menu > setup" > [OK].
2. "date/time" > [OK].
3. "time" > [OK].
4. Press the [Up] or [Down] button to set the commissioning time,
confirm with [OK].
The settings are saved.
9.7.4 Setting the date
1. "main menu > setup" > [OK].
2. "date/time" > [OK].
3. "date" > [OK]. The current date is displayed.
4. Press [OK] to confirm, or use the [Up] or [Down] button to set
the commissioning date. Confirm with [OK].
9.7.5 Setting or cancelling daylight saving time
1. "main menu > setup" > [OK].
2. "daylight.sav.t.."> [OK].
3. Use the [Up] or [Down] button to make your settings.
9.7.6 Changing the display contrast
1. "main menu > setup" > [OK].
2. "display" > [OK].
The display contrast is shown in percent.
3. Press [Up] to increase the contrast, press [Down] to reduce
the contrast. Confirm with [OK].
The settings are saved.
9.7.7 Software version
1. "main menu > service > program version" > [OK].
program version
Oxiperm Pro 162
5 g/h
V 1.03.0
2. View program version > [Esc].
These instructions are not valid for software
Note
Note
version older than V 1.03.0.