Limited Warranty; Symbols Used In This Document; General Safety Instructions; Purpose Of These Operating Instructions - Grundfos Oxiperm Pro OCD-162 Instrucciones De Instalación Y Programación

1. Limited warranty

Products manufactured by GRUNDFOS PUMPS CORPORATION
(Grundfos) are warranted to the original user only to be free of
defects in material and workmanship for a period of 24 months
from date of installation, but not more than 30 months from date
of manufacture. Grundfos' liability under this warranty shall be
limited to repairing or replacing at Grundfos' option, without
charge, F.O.B. Grundfos' factory or authorized service station,
any product of Grundfos' manufacture. Grundfos will not be liable
for any costs of removal, installation, transportation, or any other
charges which may arise in connection with a warranty claim.
Products which are sold but not manufactured by Grundfos are
subject to the warranty provided by the manufacturer of said
products and not by Grundfos' warranty. Grundfos will not be
liable for damage or wear to products caused by abnormal
operating conditions, accident, abuse, misuse, unauthorized
alteration or repair, or if the product was not installed in
accordance with Grundfos' printed installation and operating
instructions.
To obtain service under this warranty, the defective product must
be returned to the distributor or dealer of Grundfos' products from
which it was purchased together with proof of purchase and
installation date, failure date, and supporting installation data.
Unless otherwise provided, the distributor or dealer will contact
Grundfos or an authorized service station for instructions.
Any defective product to be returned to Grundfos or a service
station must be sent freight prepaid; documentation supporting
the warranty claim and/or a Return Material Authorization must
be included if so instructed.
GRUNDFOS WILL NOT BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, LOSSES, OR EXPENSES
ARISING FROM INSTALLATION, USE, OR ANY OTHER
CAUSES. THERE ARE NO EXPRESS OR IMPLIED
WARRANTIES, INCLUDING MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, WHICH EXTEND BEYOND
THOSE WARRANTIES DESCRIBED OR REFERRED TO
ABOVE.
Some jurisdictions do not allow the exclusion or limitation of
incidental or consequential damages and some jurisdictions do
not allow limit actions on how long implied warranties may last.
Therefore, the above limitations or exclusions may not apply to
you. This warranty gives you specific legal rights and you may
also have other rights which vary from jurisdiction to jurisdiction.

2. Symbols used in this document

The safety instructions are identified by the following symbols:
Warning
If these safety instructions are not observed,
it may result in personal injury.
If these safety instructions are not observed,
Caution
it may result in malfunction or damage to the
equipment.
Notes or instructions that make the job easier
Note
Note
and ensure safe operation.

3. General safety instructions

3.1 Purpose of these operating instructions

These operating instructions inform about operating and
monitoring the system with software version not older than
V 1.03.0. For information on installation, maintenance, servicing
and dismantling, please see the separate Service Instructions.
Information about possible residual risks can be found:
• on warning signs located at the installation site
• at the beginning of each section in this manual
• immediately before steps associated with a residual risk.

3.2 Operators

Operators are persons who are responsible for operating and
monitoring the system at the installation location. The system
may only be operated by trained and qualified personnel.
The system is electronically controlled. Operators operate the
system via a display with control elements.
Obligations of the operator:
• Be trained by qualified personnel from Grundfos in the
operation of the system.
• Observe the recognized regulations governing safety in the
workplace and accident prevention.
• Wear appropriate personal protective equipment in
accordance with national regulations for the prevention of
accidents when operating the system and handling chemicals.
• Control access to the operator code for the operating software.

3.3 User requirements

Owners of the building and/or operators of the Oxiperm Pro
disinfection system are obliged to:
• Keep this manual as a reference for operators while the
system remains in use.
• Meet the installation requirements specified by the
manufacturer. See section

8.1 Preparing the installation

location.
• Make sure that water and chemical lines and fittings are
regularly checked, serviced and maintained.
• Obtain official approval for storing chemicals, if necessary.
• Provide operator training for proper equipment use.
• Make sure that the labels supplied by the manufacturer are
attached and clearly visible in the installation location.
For illustration, see section
12.
• Provide the access code for the operating software only to
operators who have received appropriate technical training.
• Learn and follow all health and safety regulations (OSHA,
etc.).
• Provide all operators and service personnel with personal
protective equipment as needed.
Photos.
5