Installing And Removing The Battery - Canon EOS REBEL T6S Manual De Instrucciones

Installing and Removing the Battery

Load a fully charged Battery Pack LP-E17 into the camera. The
camera's viewfinder becomes bright when a battery is installed, and
darkens when the battery is removed.
Installing the Battery
Removing the Battery
After opening the battery compartment cover, be careful not to forcefully
swing it back further. Otherwise, the hinge may break.
34
Open the cover.
1
Slide the lever as shown by the

arrows and open the cover.
Insert the battery.
2
Insert the end with the battery

contacts.
Insert the battery until it locks in

place.
Close the cover.
3
Press the cover until it snaps shut.

Open the cover and remove the
battery.
Press the battery release lever as shown

by the arrow and remove the battery.
To prevent short circuiting of the battery

contacts, be sure to attach the protective
cover (provided, p.32) to the battery.