Set Up The Machine; Turn On The Machine - Canon imageRunner C1028i Guía De Inicio

2
Set Up the Machine

Turn on the Machine

The display returns to the Standby mode:
●
The machine may enter the Standby mode (Auto Clear function) while you are setting it up. Make the setting again from the main menu. The default setting is 2 minutes.
To change the settings, see "Introduction of the Machine" in the e-Manual.
The display turned OFF:
●
The machine may enter the Sleep mode while you are performing setup. Press
15 minutes. To change the settings, see "Introduction of the Machine" in the e-Manual.
1
Press the [I] side of the main power switch (A)
to ON.
–
Do not connect the machine and the computer with a
USB cable at this time. Connect the machine and the
computer with a USB cable only during the software
installation procedure. (A USB cable is not used when
the machine is used via a network connection.)
–
Apply the power switch label to the space above the
main power switch.
(Power) to turn the display back ON and continue the setup. The default setting is
2
If the screen to select the language appears as
shown below, use [ ▼ ], [ ▲ ] or
Wheel) to select a language, then press [OK].
The machine restarts automatically.
The language setting can be changed later.
Press (Main Menu) → <Additional Func.> →
<Common Settings> → <Language Switch> → <Done> →
Select <On> → Select the desired language → Turn OFF
the main power → Restart the machine.
3
If the screen to select the country/region
appears as shown below, use [ ▼ ], [ ▲ ] or
(Scroll Wheel) to select a country/region, then
press [OK].
The machine restarts automatically.
(Scroll
3