Spraying Instructions - Campbell Hausfeld PS460G Manual De Uso

Operating Instructions and Assembly Instructions
Airless Paint Sprayers

Spraying Instructions

read the
entire
general and Specific Safety
information sections at the
beginning of this manual
including all text under subheadings
before set up or use of this sprayer.
carbon Monoxide Hazard
an engine indoors can Kill You in
MinuteS. engine exhaust contains
carbon monoxide. this is a poison you
cannot see or smell.
neVer use inside only use
a home or garage, outSiDe and
eVen iF doors and far away from
windows are open. windows, doors,
and vents.
Professional looking results can be
obtained by following the spray tips
below.
1. Keep the gun perpendicular to the
surface.
ALWAyS hold the gun perpendicular
to the surface with the tip
approximately 12 inches from the
surface. If held at an angle (up
and down or side to side), paint
will build up unevenly, leave the
work splotchy, and cause excessive
overspray (See Figure to the right).
www.chpower.com
2. Move with a smooth arm stroke.
Move the gun at a steady, even
pace while keeping the gun
perpendicular to the surface (See
Figures to the right). DO NOT fan
the gun. Fanning the gun will cause
excessive overspray and uneven
coverage (See Figure to the right).
3. Start moving the gun before
- using
triggering.
To get a smooth overlap and prevent
initial paint buildup, start your
stroke movement before pulling the
trigger. Release the trigger before
stopping at the end of the stroke
(See Figure to the right).
NOTE: To assure uniform paint
coverage, overlap each stroke by 20%
- 30% and use two coats with a cross
pattern (one coat horizontal, second
coat vertical).
INTErMITTENT USE
If you are spraying and decide to stop
for several minutes, lock the spray
gun trigger and submerge the tip in a
container of water (See Figure). This will
prevent paint from hardening in the
tiny spray opening and clogging the tip.
Be sure to release the pressure in the
system and turn the unit off.
Over-
spray
Start
Stroke
10
12"
Holding Spray Gun
Heavy
Thin Coat
Coat
Result of Flexing Wrist While Spraying
Approx.
10-12"
Pull
Trigger
Proper Way to Trigger Spray Gun
Thin Coat
Over-
spray
Release
Trigger
End
Stroke