Preparation; Starting Instructions - Campbell Hausfeld PS460G Manual De Uso

Operating Instructions and Assembly Instructions
Airless Paint Sprayers

Preparation

gasoline fuel
and fumes are
flammable,
and potentially explosive.
use proper fuel storage and
handling procedures. Do not
store fuel or other flammable
materials nearby.
Have multiple aBc class fire
extinguishers nearby.
operation of this equipment MaY
create sparks that can start fires around
dry vegetation. a spark arrestor may
be required. the operator should
contact local fire agencies for laws or
regulations relating to fire prevention
requirements.
Airless painting systems, unlike most
other power tools, require additional
care to ensure proper working order.
Following these instructions will
significantly increase the likelihood
of having a positive paint experience.
It is important that the painting
equipment is flush/tested EACH
time a new job is started. Each
pump is tested at the factory with a
fluid that must be flushed from the
system prior to painting. It is also
required prior to each successive use
to flush the storage lubricant from
the system. Use the solvent which
will be used to clean the equipment.
Refer to the paint manufacturer's
recommendations for cleaning fluids.
HOW DO I STArT My UNIT
ALWAyS use the following start up
procedure to ensure that the unit is
started safely and properly.
DO NOT ATTACH THE SUCTION
ASSEMbLy UNTIL INSTrUCTED TO
DO SO IN STEP 3.
1. Connect 36 inch static ground clamp
and wire to the metal container.
Connect the 20 foot static ground
clamp and wire to an earth ground.
www.chpower.com

Starting Instructions

Connect ground
clamps and wires
2
Use Finger to
Check Inlet Valve
4
Attach
Suction
Assembly
2. Remove inlet valve cap and with
your smallest finger, push on inlet
valve stem to ensure it moves freely.
3. Push outlet prime button three
times to ensure outlet valve is
moving freely.
4. Attach suction assembly and bypass
tube securely and place both suction
and bypass tubes in cleaning solvent.
8
1
3
5
Turn Pressure
to HIGH
(completely clockwise)
5. Turn pressure to HIGH (completely
clockwise).
6. Turn prime/spray control to the
PRIME position.
7. The engine DOES NOT COME FILLED
WITH OIL. Check engine oil levels.
Add oil as necessary. See Page 18 for
engine oil types, quantities, and oil
changing instructions.
Push Outlet
Prime Button
6
Turn Prime/Spray
Control
to PRIME
(knob is vertical)