Campbell Hausfeld PS460G Manual De Uso página 16

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Pump Storage Instructions
SHOrT TErM - LESS THAN ONE
WEEk
WEAr ALL NECESSAry
SAFETy GEAr
NECESSAry TOOLS / MATErIALS:
• Pump Protector Solution
• Plastic Wrap
• 3/4 in. or Adjustable Wrench
OIL OR ALKyD BASED PAINT
If sprayer cleaned with mineral spirits,
simply wrap suction filter housing in
plastic to keep debris out of suction
filter. No other preparation is necessary.
WATER-BASED PAINT
1. Prepare Pump Protector solution in
bucket as directed on container.
2. Place suction assembly into solution.
3. Place end of bypass tube into waste
bucket.
4. With prime/spray control in PRIME
position, turn pressure to HIGH
(completely clockwise).
5. Turn the engine ON. Circulate Pump
Protector through bypass tube until
bucket of solution is EMPTy.
6. Turn pressure to LOW (completely
counterclockwise).
7. Wrap suction filter housing in
plastic to keep debris out of suction
filter.
LONG TErM - MOrE THAN ONE
WEEk
8. Remove high pressure hose and
drain. Reassemble high pressure
hose to pump.
9. With spray tip attached to spray
gun, wrap tip with plastic to protect
tip.
www.chpower.com
Water based Paint
1
Pump
Protector
Prepare Pump
Protector Solution
3
PUMP
PrOTECTION
SOLUTION
WASTE
bUCkET
Place End of Bypass Tube
into Waste Bucket
6
Turn Pressure to LOW
(completely counterclockwise)
16 16
2
PUMP
PrOTECTION
SOLUTION
WASTE
bUCkET
Place Suction
Assembly in
Solution
4
WASTE
bUCkET
With Prime/Spray
Control in PRIME
Position, Turn
Pressure to HIGH
(completely clockwise)
7
Wrap Suction Filter
Housing in Plastic
PUMP
PrOTECTION
SOLUTION