Campbell Hausfeld PS460G Manual De Uso página 11

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Spraying Instructions
(Continued)
CLEArING CLOGS
REVERSIBLE TIP: (INcLudEd)
1. Rotate the tip to the CLEAN position
(See Figure to the right).
2. Point gun in a safe direction and
spray. This should clear tip of any
blockage.
3. Rotate the tip back to the SPRAy
position and continue spraying (See
Figure to the right).
4. If clogging continues, replace gun
filter and consider straining the
paint prior to use.
equipment damage
can occur if a needle
or sharp object is used to clean the tip.
tungsten carbide is brittle and can be
chipped.
HOW TO CHANGE SPrAy TIPS
It may be necessary to change spray tips
during a paint job. Follow these steps
for safe, easy tip changes.
1. Depressurize and turn off unit per
manufacturer's instructions.
2. Engage gun trigger lock.
3. Pull red tip insert
out of spray base
and replace with
different tip, fully
inserting tip into base.
HOW TO ATTACH rOLLEr ACCESSOry
1. Depressurize and turn off unit per
manufacturer's instructions.
2. Engage gun trigger lock.
3. Remove spray base, tip, seal and
washer assembly.
4. Attach roller accessory (AL2275
shown) to airless spray gun. If
needed use thread adapter and
washer between roller and spray gun
as shown.
Figure - Attach roller accessory to spray gun
11
1
CLEAN Position
2
SPRAy Position
Water
Prevent clogged tip
ground the gun
by holding
it against the edge of the metal
container while flushing. Failure to
do so coulD lead to a static electric
discharge, which coulD cause a fire.
www.chpower.com